Clarion CZ703E Manuel D’Utilisation

English

17

CZ703E

1.  Push the trim ring to right and pull out the 

right part.

           

2.  Push the trim ring to left and pull out the 

left part.

        

1.  Switch off the power.

2.  Remove the DCP. 

3.  Remove the trim ring.

4.   Insert the removal keys straight back until 

they lock, then pull the unit out. 

5.  Disconnect all the wires.

Mounting Frame

Dashboard

M5x6

1.  Insert this unit directly to the opening of 

the dashboard.

2.  Place M5×6 cylindrical screw through the 

holes of the mounting frame located inside 

the opening to holes of the unit and fasten 

the screws to left & right.

Attach the trim ring around the front panel.

Take care of the top and bottom of the trim 

ring and mount it so that all the hooks are 

locked.

 

Top

Bottom

1.  Before installation, please make sure 

proper connections are conducted and 

the unit operates normally. Improper 

connection may result in  damage to the 

unit.

2.  Use only accessories designed and 

manufactured for this unit and other 

unauthorized accessories may result in 

damage to the unit.

3.  Before installation, please fasten all power 

cables.

4.  DO NOT install the unit in the place where 

close to hot area to prevent damage to 

electrical components such as the laser 

head. 

5.  Install the unit horizontally. Installing the 

unit more than 30 degree vertically may 

result in worse performance.

6.  To prevent electric spark, connect the 

positive pole first and then the negative 

pole.

7.  DO NOT block the cooling fan exit to 

ensure sufficient heating dissipation of this 

unit, or it may result in damage to this unit.

1.  Insert mounting bracket into dash board, 

choose appropriate mounting tab according 

to the gap width, bending the mounting 

tab outwards with a screwdriver to fix the 

mounting bracket in place. 

2.  Screw in 1 piece of M4×42 to the hole of 

the unit back and put on a rubber cap over 

the screw. (see picture below)

3.  Slide the unit into the bracket until you hear 

a click sound.

Rubber cap

Special Screw (M4x42)

Screwdriver