Sygonix Surveillance Camera 24490X 24490X Manuel D’Utilisation

The home technology brand for the entire house. More information at www.sygonix.com

•  The camera should not be exposed to extreme temperatures, direct sun-

light, strong vibrations or heavy mechanical stress.

•  Make sure that the connection cable is not pinched or damaged by sharp 

edges.

•  Do not leave packaging material carelessly lying around, since it could be-

come a dangerous plaything for children.

•  Handle the product with care; it can be damaged by impacts, blows, or ac-

cidental falls, even from a low height.

•  If the camera is used with other devices (e.g. a monitor), the operating in-

structions and safety notices for these devices must be followed.

•  Safe operation can no longer be assumed if:

  -  the device is visibly damaged,

  -  the device no longer works 

  -  the device has been stored under adverse conditions for a long time

  -  it was exposed to heavy loads during transport

•  In commercial institutions, the accident prevention regulations of the Em-

ployer’s Liability Insurance Association for Electrical Systems and Operating 
Facilities are to be observed. 

•  If you have any questions that are not answered in this manual, please con-

tact our technical service or another specialist.

The camera should not be pointed directly towards bright sources of light or 
the sun, since this will overexpose the image.

For outdoor use, we recommend choosing a location that is protected from 
precipitation / sprayed water (e.g. under the eaves) to prevent the formation 
of droplets or the collection of sprayed water on the camera's front panel that 
will cause a distorted and unusable image.

Thanks to the relatively small design, installation is possible in various loca-
tions that are not accessible using conventional surveillance cameras.

•  The special holding bracket makes it possible to install the camera on a wall as well 

as on the ceiling. 

   Loosen the large round knurled fi xing ring (turn left counter-clockwise) and align 

camera and holding bracket as desired with respect to each other. 

   By loosening the two Allen screws with the provided Allen key, you can adjust the 

camera in inclination and rotation and thereby select the desired monitoring area 
optimally.

•  To lay the connection cable invisibly, an appropriately large hole can be drilled at the 

mounting site (when you plug the jack, protect it against dust and dirt with some-
thing like a piece of tape).

   Alternatively, you can use the opening in the holding bracket through which the ca-

ble can be led out of the side. In this case, a suitable protective tube for the cable is 
recommended to prevent manipulation attempts.

•   Depending on the mounting location, use appropriate screws and, where necessary, 

wall plugs to attach the bracket. 

Make sure when screwing into place or when drilling holes that cables or wires 
are not damaged.

This camera is intended for monitoring and protecting secluded or critical areas (e.g. 
entrance areas, surveillance of underground car parks, stairwells and the like). 

The product is designed for use indoors and outdoors (IP65). 

The camera is intended to be used only with a stabilised mains voltage of 12V/DC.

Please bear in mind that it is prohibited by law to observe strangers with a camera 
without their knowledge and consent. Observe the rules and regulations of the coun-
try where you are using the camera.

The safety instructions must be observed at all times!

Any use other than that described above could lead to damage to this product and 
involves the risk of short circuits, fi re, electric shock, etc. No part of the product may 
be modifi ed or converted!

This product complies with the applicable national and European requirements. All 
names of companies and products are the trademarks of the respective owners. All 
rights reserved.

• Colour camera

• Allen key

• Assembly material

• Operating instructions

This symbol indicates specifi c risks associated with handling, function and 
use. 

The "arrow" symbol indicates special tips and operating information.

•  The unauthorised conversion and/or modifi cation of the product is not per-

mitted for safety and approval reasons (CE). Never dismantle the product.

•  The camera is intended to be used only with a stabilised direct current of 

12 V/DC. The inner contact of the round plug should be Plus/"+", the outer 
contact Minus/"-".

•  The product is not a toy and should be kept out of the reach of children. It 

should be operated out of the reach of children.

•  The use of the surveillance camera system does not replace the personal 

supervision of children or people who require special assistance, but serves 
only as a support to this supervision.

•  The camera is suitable for use in indoor and outdoor areas (IP65). However, 

it must never be used in or under water, as this will destroy it.

   The plugs on the camera's connection cable are not waterproof or water-

tight and must therefore be placed in a dry indoor area.

Operating instructions
CMOS Colour Camera, 600 TVL, 3.6 mm