Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Fiche De Données

● Select the function name

and return to the Model

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s

pushed.

Use this mix when you want to suppress the 

reaction torque generated by main rotor pitch and 

speed changes during pitch operation. Adjust so 

that the nose does not move in the rudder direction.

 The mixing curve rate should be started

using smaller values.

 For  a  rotor  with  a  clockwise  operation

direction, when pitch was input at the plus

side, set these parameters so that mixing

is in the clockwise direction. First, trim at

hovering  and  then  adjust  the  neutral

position.

1. Adjustment between slow and hovering
 Repeatedly hover from take off and land

at a constant rate matched to your own

rhythm. Then adjust the pitch so that the

nose  of  the  helicopter  remains  steady

when the throttle is raised and lowered.

2. Throttle high side (climbing and diving from

hovering)

 Repeat climbing and diving from hovering

at a constant rate matched to your own

rhythm and adjust the pitch so that the nose

does not deflect when the throttle is raised

and lowered.

 Set the mixing rate so that the rudder direction

at high-speed flight is straight ahead. Adjust for

each condition used.

●  Select  [PIT  to  RUD]  at  the  Model

menu and access the setup screen

shown below by touching the RTN

button.

(Currently selected condition name)

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

 When using this function, move the cursor to

the [ACT] item and touch the RTN button to

switch to the data input mode.

 Select the ACT mode by scrolling the touch

sensor.

*The display blinks.

 Touch the RTN button to activate the mixing

and  return  to  the  cursor  mode.  (ON  is

displayed.)

 Move the cursor to the curve rate setting

item you want to adjust and touch the RTN

button to switch to the data input mode.

 Adjust the rate by scrolling the touch sensor.
 Initial value: P1~P5: 0%
 Adjustment range: -100%~+100%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

 Touch the RTN button to end the adjustment

and return to the cursor mode.

 Repeat this procedure for each point.

 Move the cursor to COPY item and touch the

RTN button to switch to the data input mode.

Select  the  copy  destination  condition  by

scrolling the touch sensor and touch the RTN

button. Select the [YES] and touch the RTN

button.