Whirlpool W10029770A Manuel D’Utilisation

Page de 28
10
8. Replace terminal box cover.
9. Check all light bulbs to make sure they are secure in their 
sockets.
10. Reconnect power.
Complete Installation
1. Install vent cover.
Push lower cover down onto hood and lift upper cover to 
ceiling and install with two 2.9 x 9.5 mm screws.
Connect the upper and lower vent covers with 
two 3.5 x 9.5 mm screws apiece from the inside of the hood.
Install Filters
1. For non-vented (recirculating) installations, install charcoal 
filter over grille on blower housing and turn filter handle 
clockwise. Repeat with other charcoal filter.
2. For all installations, insert back edge or metal filter into rear 
channel of the filter opening.
3. Push handle toward the rear and push filter up.
4. Pull filter toward the front and insert into front channel.
Check Operation
1. Press the light button 
. The light should turn on.
2. Press the “1” button. The blower should operate.
3. Press the “1” button for low speed, “2” button for medium 
speed or “3” button for high speed.
4. Press the “0” button to turn off the blower.
5. If range hood does not operate, check to see whether a 
circuit breaker has tripped or a household fuse has blown.
6. Disconnect power supply.
7. Check that the wiring is correct.
8. Replace all parts and panels before operating.
9. Reconnect power.
NOTE: To get the most efficient use from your new range hood, 
read the “Range Hood Use” section.
RANGE HOOD USE
Operation
The canopy hood is designed to remove smoke, cooking vapors 
and odors from the cooktop area. For best results, start the hood 
before cooking and allow it to operate several minutes after the 
cooking is complete to clear all smoke and odors from the 
kitchen.
Hood control panel
The hood controls are located on the front side of the canopy.
Operating the light
1. Press the light button 
 to turn on the light.
2. Press the light button 
 to turn off the light.
Operating the blower and adjusting blower speed
1. Press the “1” button for low speed, “2” button for medium 
speed, “3” button for high speed.
2. Press the “0” button to turn off the blower.
A. Upper vent cover
B. Lower vent cover
C. 2.9 x 9.5 mm screws
D. 3.5 x 9.5 mm screws
E. Bracket
A. Blower housing
B. Filter handle
C. Charcoal filters
A
B
D
C
C
E
A
B
C
C
0
1
2
3
0
1
2
3