Whirlpool 1328891 Manuel D’Utilisation

■

The power supply cord is unplugged. Plug into a grounded 
3 prong outlet. See “Electrical Requirements.”

■

Time-delay fuse or circuit breaker of the wrong capacity 
is being used. Replace with a time-delay fuse or circuit 
breaker of the correct capacity. See “Electrical 
Requirements.”

■

The power supply cord has tripped (Reset button has 
popped out). Press and release RESET (listen for click; Reset 
button will latch and remain in) to resume operation.

■

A household fuse has blown, or a circuit breaker has 
tripped. Replace the fuse, or reset the circuit breaker. See 
“Electrical Requirements.”

■

The On/Off button has not been pressed. Press ON/OFF.

■

The local power has failed. Wait for power to be restored.

■

Too many appliances are being used on the same circuit. 
Unplug or relocate appliances that share the same circuit.

■

You are trying to restart the air conditioner too soon after 
turning off air conditioner. Wait at least 3 minutes after 
turning off air conditioner before trying to restart the air 
conditioner.

■

You have changed modes. Wait at least 3 minutes after 
turning off air conditioner before trying to restart the air 
conditioner.

■

Disturbances in your electrical current can trip (Reset 
button will pop out) the power supply cord. Press and 
release RESET (listen for click; Reset button will latch and 
remain in) to resume operation.

■

Electrical overloading, overheating, cord pinching or 
aging can trip (Reset button will pop out) the power 
supply cord. After correcting the problem, press and release 
RESET (listen for click; Reset button will latch and remain in) 
to resume operation. If the power cord fails to reset, contact a 
service technician.

NOTE: A damaged power supply cord must be replaced with a 
new power supply cord obtained from the product manufacturer 
and must not be repaired.

■

Is there a door or window open? Keep doors and windows 
closed.

■

The current air conditioner replaced an older model. The 
use of more efficient components may cause the air 
conditioner to run longer than an older model, but the total 
energy consumption will be less. Newer air conditioners do 
not emit the “blast” of cold air you may be accustomed to 
from older units, but this is not an indication of lesser cooling 
capacity or efficiency. Refer to the efficiency rating (EER) and 
capacity rating (in Btu/h) marked on the air conditioner.

■

The air conditioner is in a heavily occupied room, or heat-
producing appliances are in use in the room. Use exhaust 
vent fans while cooking or bathing and try not to use heat-
producing appliances during the hottest part of the day. 
Portable air conditioners are designed as supplemental 
cooling to local areas within a room. A higher capacity air 
conditioner may be required, depending on the size of the 
room being cooled.

■

Set temperature is close to room temperature. Lower set 
temperature. See “Portable Air Conditioner Use.”

■

The filter is dirty or obstructed by debris. Clean the filter. 

■

Air outlet is blocked. Clear air outlet.

■

Set temperature is too high. Lower set temperature.

■

The air conditioner is not properly sized for your room. 
Check the cooling capabilities of your portable air 
conditioner. Portable air conditioners are designed as 
supplemental cooling to local areas within a room. 

■

The filter is dirty or obstructed by debris. Clean the filter. 

■

There is excessive heat or moisture (open container 
cooking, showers, etc.) in the room. Use a fan to exhaust 
heat or moisture from the room. Try not to use heat-
producing appliances during the hottest part of the day.

■

The louvers are blocked. Install the air conditioner in a 
location where the louvers are free from curtains, blinds, 
furniture, etc.