Whirlpool 15080000 Manuel D’Utilisation
Document ID:15080000
Rev: E
Technical Support: 800-626-6912
Page 13 of 20
Installing and Removing the Side Panels
To install the side panels on your spa follow the instructions below:
Step 1: Slightly lift side panel into
place on spa frame.
Step 3: Make certain that the side
panels lay above the frame at
the top of the basin, as shown
above.
above.
Step 5: Align the thumbscrew
holes located under cushion
skirt, and screw in the
thumbscrew.
thumbscrew.
Step 2: Align the magnets on the
frame legs with matching
brackets found on the inside of
the side panel. There is one set
the side panel. There is one set
on each leg.
Step 4: The side panel should fit
under the lip of the basin, as
shown above.
Step 6: Install the front plate by
aligning the magnets to the
matching brackets and pressing
into place.
into place.
To remove side panels: Reverse steps one through six.
Installing the Floor Mounting Brackets
All Platino Spas installed with gravity drain and / or hard piped to hot and cold supply lines
MUST be anchored to the floor.
MUST be anchored to the floor.
To install the floor mounting brackets on your spa follow the instructions below:
Step 1: Adjust the leveling feet until you have at least
a ¼” gap.
Step 2: Place the floor mounting brackets on to
leveling feet diagonally from each other. (2
brackets provided)
brackets provided)
Step 3: Mark spots to be drilled. Bracket has ½” hole. If mounting to floor, use (2) 3/8” floor lag bolts with
washer – not provided.