Summit FFBF181SSIM Manuel D'Instructions

253479

Required tools: socket wrench no. 8, screwdriver, torx 25.
Caution! After unscrewing or before fi xing hinges, hold the door 
to prevent it from falling and being damaged.
1.  Remove upper hinge cover (save it for later use). Also remove 

the cover on the opposite side of the upper hinge cover (you 
will insert the attached cover on the other side during the 
assembly).

2.  Unscrew upper hinge screws and remove the upper door from 

the middle hinge.

3.  On the lower edge of the upper door unscrew the swing 

stopper screws and remove the stopper (A). Keep this for 
eventual use later on. Fix the attached stopper with its 
bearing on the opposite side of the door.

4.  Unscrew the forced door closure system (B) and fi x it to the 

opposite side of the door (certain models only).

5.  Unscrew middle hinge screws, remove the door  from bottom 

hinge.

6.  Loosen the screws fi xing the leg supports (certain models 

only), then continue with either procedure 7 or 7.1 below, 
depending on the model of the appliance.

7.  Tilt the appliance backward (max. 35°) and let it rest against 

a fi rm support. Unscrew the leg support screws (C) - left and 
right, and remove the leg support cover (D) and place it on 
the opposite side. Unscrew and remove, then reverse the 
positions of end switch (E) and decorative peg (F).

 

(For models with a forced door closing system, undo the three 
screws attaching the lower hinge and install the hinge on the 
opposite side.)

7.1.Tilt the appliance backwards (max. 35°) and let it rest against 

a fi rm support at the back.

 

Undo the three screws attaching the lower hinge and install 
the hinge on the opposite side. Plug the holes left after this 
installation with the appropriate pegs.

8.  Repeat procedures 3 and 4 on the bottom door. In case there 

is no bottom door limit peg, transfer the bearing (G) and 
washer to the opposite side of the door.

9.  Proceed with the assembly procedure in opposite sequence.

8