Whirlpool XHPC155XL Manuel Du Propriétaire
2
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools Needed:
Utility knife
1/4" hex-head ratchet
or open-end wrench
Level
9/16" open-end wrench
Pliers or slip-joint pliers Bucket
1/4" nut driver
5/16" hex-head ratchet
or nut driver
INSTALLATION REQUIREMENTS
LOCATION REqUIREMENTS
Additional Items Needed:
Towel
Sponge
Parts Supplied:
Four #12 x 5/8" hex-head
Drawer divider
sheet metal screws
NOTE:
If the washer/dryer and pedestal assembly are located in
a garage, 3" (76 mm) must be added under the pedestal so that
the washer/dryer is 18" (460 mm) above the garage floor.
1.
Empty pedestal drawer
UNPACKING THE PEDESTAL
Open the pedestal drawer as far as possible and remove the
contents. The package contains four, #12 x 5/8" hex-head sheet
metal screws and a drawer divider.
Preparing the pedestal for installation
IMPORTANT: Set the pedestal box aside for use during
installation.