Whirlpool XHPC155XL Manuel Du Propriétaire

NOTE: If the washer is to be transported, call your local service 

center. To avoid suspension and structural damage, your  

machine must be properly set up for relocation by a certified 

technician.
1.  Turn off the hot and cold water faucets. 
2.  Unplug the power supply cord. 
3.   Slowly loosen the fill hoses at the faucets to relieve the water 

pressure. Use a sponge or towel to absorb the released water.

4.   Remove the “HOT” and “COLD” fill hoses from the back of the 

washer. Drain the water from the hoses into a bucket. 

 5.   Remove the drain hose from the standpipe or laundry tub and 

drain any water remaining in the hose into a bucket.

6.   Pull the washer away from the wall so that you will have 

enough space for the installation. 

 

If your washer and dryer are already installed, they 

must be uninstalled.

Using a 1/4" nut driver, remove the hex-head screws from both 

drawer slides and save screws. Remove the drawer from the 

slides and set aside.  Push the slides back into the pedestal.

The four spacer pads are installed on the top of the pedestal. 

These pads reduce vibration between the pedestal and the 

washer/dryer.