Agilent Technologies E6380-90073 Manuale Utente
Chapter 1
233
GPIB Command Dictionary
MEASure subsystem
:CDANalyzer:TRACe:TOFFset?
IS-95 Only mode. This command queries the timing in the 64 trace
points of the code domain analyzer. The measurement returns 64 values
(in seconds), one for each point.
points of the code domain analyzer. The measurement returns 64 values
(in seconds), one for each point.
Syntax
MEAS:CDAN:TRAC:TOFF?
Screen/field equivalent
MEAS:CDAN:TRAC:TOFF? does not correspond to any field on the
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.
:CDANalyzer:TRACe:PERRor?
IS-95 Only mode. This command queries the phase in the 64 trace
points in the code domain analyzer. The measurement returns 64
values (in radians), one for each point.
points in the code domain analyzer. The measurement returns 64
values (in radians), one for each point.
Syntax
MEAS:CDAN:TRAC:PERR?
Screen/field equivalent
MEAS:CDAN:TRAC:PERR? does not correspond to any field on the
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.
:CDANalyzer:TRACe:TPOWer?
IS-95 Only mode. This command queries the absolute (true) power in
each of the 64 Walsh channels, relative to the total power inside a 1.23
MHz bandwidth centered at the tune frequency. The measurement
returns 64 values (in dB), one for each point.
each of the 64 Walsh channels, relative to the total power inside a 1.23
MHz bandwidth centered at the tune frequency. The measurement
returns 64 values (in dB), one for each point.
Syntax
MEAS:CDAN:TRAC:TPOW?
Screen/field equivalent
MEAS:CDAN:TRAC:TPOW? does not correspond to any field on the
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.
CODE DOM screen. This applies when the CDMA standard is set to
“IS-95 Only”.