Ironman Fitness V2 Manuale Utente
21
Powering the Detector
When you first remove the detector from the box it is not
powered, although the batteries are in place. To turn the
detector on
−
Pull the piece of plastic out from beneath one of
the battery terminals (as seen in figure 3).
As soon as the plastic is removed the red and green
lights will flash for a few seconds.
You must wait approximately
3 minutes
for the detector
to warm up after connecting the batteries.
This time starts from when the detector starts flashing
both red and green lights after removing the piece of
plastic from under one of the battery terminals.
During this period the detector
will not
respond
and
should be left untouched until the 3 minute period is up.
3 minutes after power up, the green and red lights will
flash together 6 times to indicate the detector is exiting
test mode.
The detector will now automatically enter
Intelligent
Power Saving
(IPS) mode.
TIP
for continued trouble free operation please insure
the batteries are clean with no fingerprints
IMPORTANT
Warm up period
Figure 2
Unclip the
front
cover as
shown
Figure 3
Plastic under battery