Ironman Fitness V2 Manuale Utente
22
Walk Test Mode for the Passive Infrared detectors and other wireless devices
It is vital that the detector is tested carefully for each installation. At 25°Celsius, the detector
should have a detection range of approximately 10 metres and a scope angle of 90°, i.e. 45°
either side of the centre position straight ahead of the lens.
Walk Test Mode For The Wireless PIR Detectors
1.
Remove the front cover off the detector via the clip at the
top. The green and red lights will flash together, 6 times, to
indicate that the detector has entered test mode.
2.
Replace the front cover.
3.
The detector will stay in walk test mode for 3 minutes. It
may be triggered as often as desired during this period.
Once in test mode
Now the detector can be triggered constantly for the next 3 minutes. Walk past the detector
to test the detection range. When movement is detected the green light will flash to indicate
one pulse count. When 3 pulse counts are detected the red light will flash to indicate a valid
movement and that the alarm code signal has been sent back to the main control unit.
Adjusting The Detection Sensitivity
PULSE COUNT SELECT Jumper
ON
Least sensitive – 3 pulse counts
OFF
Most sensitive – 2 pulse counts
The sensitivity of the detector can be changed by either
removing the ‘Pulse Count Select’ jumper or by placing it
across both pins. When the jumper is placed across both
pins (default), then the detector is set to 3 pulse counts
(least sensitive). When the jumper is removed or only
attached to 1 of the pins, then the detector is set to 2 pulse
counts (most sensitive).
Pulse count jumper
Once you have set the jumper, you must press the tamper
switch in for 1 second then release it for the setting to
become active. Now you can place the front cover back on
the detector.
Tamper switch