Ironman Fitness V2 Manuale Utente
38
Below you will find an explanation of the different operational modes of your Watchguard
Digital Alarm and when it is appropriate to use them
AWAY Mode
This mode activates all wireless detectors
When to use
When leaving the building or premise, i.e. AWAY from premises.
Indications
The siren will beep once and the strobe will flash once. The red warning light will turn on.
The internal screamer will beep for the 30-second exit delay before the system is fully
armed. During this delay only the 24 hour detectors (e.g. smoke detectors) and tamper
signals will trigger the alarm. Once the system is fully armed the red LED indicator will begin
flashing at 1-second intervals on the Main Control Unit.
Triggering
If a detector is triggered when the system is fully armed, the siren and internal screamer will
sound for 5 minutes or until the system is disarmed (which ever occurs first).
Each detector
zone can only trigger the siren once in one arming period, as per Australian
Standards requirements.
When an alarm is triggered, your panel will connect to the SecureNet Digital Monitoring
Centre. If your alarm system is unable to contact the SecureNet DIGITAL MONITORING
CENTRE it will retry sending the message five times. If still unable to contact the SecureNet
DIGITAL MONITORING CENTRE the alarm communication will be discarded. It is therefore
important to ensure that your phone line is always connected to your Watchguard Digital.
STAY Mode
This mode is used for protecting only a selected area(s) of the building while you (and
others) are on the premises or someone is
STAYING
home
When to use
Generally used at night while sleeping.
Indications
The siren will beep one low tone beep after the second time button 1 is pressed. The red
warning light will turn on the main control unit. The internal screamer will beep at 2-second
intervals for the 20-second delay before the system is armed in STAY mode. The red
warning light will now flash at 2-second intervals on main control unit.
Triggering
Arming the system in this mode will enable only Zone 1 (default), unless other extra
detectors that have been programmed to trigger the alarm in STAY mode. When any stay
mode detectors are triggered in this mode after the 30-second exit delay the siren and
internal screamer will beep 5 times.
DISARMING
Remotes:
The system should be disarmed via button number 2 on the remote before
entering the building or premise.