Ironman Fitness V2 Manuale Utente
37
Operation
Master Key switch On Main Control Unit
The master key switch is located on the Main Control Unit. The master key switch allows
you to completely disable the alarm system, and is used primarily for transportation purposes
so as not to flatten the internal back-up battery unnecessarily. Leaving the switch on without
main power connected will cause long-term damage to the battery cells.
To utilise your Watchguard Digital, turn the key switch to the ‘ON’ position. Two keys are
provided with the kit, and it is suggested you keep them on each key ring with your remote
controls. When you switch on the system, the LED on the Main Control Unit will flash once
every 5 seconds to indicate that the unit is active.
When unit is turned on for the first time it will automatically enter Walk test mode - unless
the cover is on - which will allow you to test that each device had good signal coverage. To
exit walk test mode Arm/Disarm the alarm or wait 20 minutes and it will exit automatically.
Key switch Located
(On the Main Control Unit)
Exit & Entry Delays
Your Watchguard Digital is equipped with Entry and Exit Delay Warning capabilities.
Exit Delay
is a 30 second delay before the alarm is actually armed; this delay is to provide
the user with sufficient time to exit the premises. During the Exit Delay the internal screamer
of the alarm will chirp at 1-second intervals.
Entry Delay (For Use With The Optional Wireless Keypad)
The programmable Entry Delay is 30 seconds. The purpose of this function is to allow users
to disarm the alarm system within the delay before the alarm is set-off (triggering the
Screamer, Siren/ Strobe and communicating with the DIGITAL MONITORING CENTRE).
The Entry Delay is turned off as standard. For it to be functional, the wireless alarm zones
you would like an entry delay on must be programmed via the optional Wireless Keypad. For
information on how to program Entry Delay on a particular zone please refer to the zone
programming section of this manual on page 44.
Red LED Indicator Main Control Unit
The red LED indicator is located on the bottom right corner of the main control unit.
This indicator will flash to indicate the current status of the system:
Flashing once every second
=
Armed
Flashing once every 2 secs
=
Home/Armed
Flashing Once Every 5 Secs
=
Disarmed
On Steady
=
Exit Delay In Progress
Fast Flashing
=
System Is In Program Mode
Blinking Off Every 5 Seconds
=
Power On Walk Test Mode