Heat Controller MMH36TA-1 Manuale Utente

(1) Remove two-caps on the conduit panel.

(for low voltage line)

(2) Pull the connection cable through conduit.
(3) After conduit is through the panel, secure the nut

on the opposite side of panel.

(4) Pass the connection cable through the hole.
(5) Properly connect the cable onto the terminal

block.

(6) Secure the connection cable with cord clamp

provided on the unit to reduce strain at the
terminal when the connection cable is pulled
outside up to a 35 pound weight

When connecting each power wire to the
corresponding terminal, follow instructions "How
to connect wiring to the terminals" and fasten the
wire tightly using the screw on of the terminal
plate.

For strand wiring

(1) Cut the wire end with a wire cutter or wire-

cutting pliers, then strip the insulation to
expose the strand wiring about 10 mm(3/8").

(2) Using a screwdriver, remove the terminal

screw(s) on the terminal plate.

(3) Using a round terminal fastener or pliers,

securely clamp each stripped wire end with a
round terminal.

(4) Position the round terminal wire, and replace

by tightening the terminal screw using a
screwdriver.

High voltage

Low voltage

Str

ip 10 mm(3/8")

Round
terminal

Connecting cable

Loosening the
terminal block
screw

Fastening the 
wire tightly

Strand wire

G

Terminal
block

Lock nut

Power supply line

(1ø, 230/208V)

Conduit panel

Cap(Reuse)

Cord clamp

Hole
(for low voltage line)

Cap(Remove)
Taping
(for sealing)

Low voltage line
(connecting cable)