Jensen CD1213 Manuale Utente

CD1213

6

Up to six stations on each band can be stored 

as presets and can then be instantly recalled by 

pressing the associated preset button on the 

front panel (19-24) or remote control. To store a 

station, turn the radio on and select the desired 

band and station. Press and hold the desired 

preset button (numbered one through six on the 

face of the radio or remote control) for more 

than two seconds. When stored, the preset 

number will appear in the display. The station is 

now stored and can be recalled at any time by 

pressing the corresponding preset button. 

Repeat for the remaining five presets on the 

current band and for all presets on the other 

three bands.

Automatically Store
Select six strong stations and store them for all 

bands  using the Automatic Store feature. To 

enable this feature, press and hold the PS/AS 

button (17) for more than two seconds. The 

radio will automatically scan each band and 

enter strong stations into the preset memory 

positions. After entering the stations into 

memory, the unit will automatically stop at each 

station for five seconds so each can be heard. 

When using the Automatically Store feature, the 

new stations replace any stations already 

stored in preset memory.
Preset Scan
Press the PS/AS button (17) to scan the six 

preset stations in the AM band or all FM bands. 

The unit will stop at each station for five 

seconds before continuing to the next preset 

station, and the preset number will flash on the 

display during the preset scan. Press PS/AS 

again to stop scanning and listen to the current 

station.

Press MONO (18) during FM radio operation to 

select mono reception of the broadcast signal. 

Under normal reception, the unit should be left 

in the stereo mode, as indicated by the “ST” 

designation that appears on the display panel 

when tuned to an FM stereo signal. If the signal 

is too noisy for comfortable listening, press 
MONO

 to switch to mono reception. The “ST” 

indication will disappear. Press MONO again to 

return to stereo mode.

This feature is used to designate the strength of 

the signals at which the radio will stop during 

automatic tuning. Distant, or “Dx” is the default 

setting, allowing the radio to stop at a broader 

range of signals. To set the unit to select only 

strong local stations during automatic tuning, 

press the LO/DX button (25). The “LOC” icon 

appears in the display when LOCAL reception 

mode is selected.