Creative Dxr2 Manuale Utente

English

Step 4: Connect 
PC-DVD to Your 
Computer

You can now connect the PC-DVD drive to the IDE controller on your computer’s motherboard.  The 
motherboard should have two IDE connectors:  Primary is usually used by your hard disk drive; 
secondary is used by devices such as CD-ROM drives.  Refer to your computer’s documentation for the 
location of the IDE connectors.

Connect the PC-DVD drive to one of the following:

❑

Secondary IDE connector (recommended)
See “Secondary IDE Connector,”  below.

❑

❑

Secondary IDE 
Connector

1.

Set the the PC-DVD drive as the master drive by placing the 
jumper block as shown.

2.

Locate the secondary IDE connector on the motherboard.

3.

Connect the IDE data cable to the secondary IDE connector, align 
the colored stripe on the cable to pin 1 of the IDE connector.

4.

Connect the PC-DVD audio cable to the Dxr2 decoder card’s Audio In connector (see “Dxr2 
Decoder Card” on page 3).

5.

Slide the drive back into place and use the screws provided to secure it to the computer.  Proceed 
to “Step 5: Connect Other Devices to the Dxr2” on page 12.

Master

Slave

(default)

Dvd-fm.book  Page 9  Thursday, December 17, 1998  9:44 AM