Creative Dxr2 Manuale Utente

Secondary IDE 
Connector with 
CD-ROM Drive

1.

Locate the secondary IDE connector on the motherboard.

2.

Set the jumpers on the PC-DVD drive as master and the jumpers on the CD-ROM drive as slave 
(see the figure on page 2).

3.

Connect the PC-DVD drive to the CD-ROM drive with the IDE data cable as shown below.

4.

Connect your new PC-DVD drive to the secondary IDE connector using the IDE data cable as 
shown below.

5.

Connect the PC-DVD audio cable to the Dxr2 decoder card’s Audio In (1) connector, and the CD 
audio cable to the Dxr2 decoder card’s Audio In (2) connector (see the figure page 3 for location 
of the connectors).

6.

Slide the drives into place and secure them to the computer using the screws provided.

7.

Note:  Align the colored stripe on 
the IDE data cable to pin 1 of the 
drives’ IDE data connectors.

Pin 1

IDE data 
connector

Power 
cable

Colored 
stripe

Pin 1

Power 
cable

CD audio cable

CD-ROM drive
(slave)

PC-DVD drive
(master)

PC-DVD 
audio cable

Daisy-chaining the PC-DVD 
drive with a CD-ROM drive may 
be used with Windows 95 OSR2 
(version 4.00.950B) only—it is 
not recommended for other 
versions of Windows 95.

Dvd-fm.book  Page 10  Thursday, December 17, 1998  9:44 AM