Tyco 0-1591700-x Manuale Utente

Traps are used by the access point to automatically send alarm information to remote IP 
addresses.  

This is the same index value as assigned in the SNMP Community on page 29. 
Version 
This pull-down box allows the SNMP version to be assigned. The following options are supported:- 

•  Disable – This disables the SNMP trap generation. 

•  Version 1 – This configures the SNMP trap message to use the SNMP V1 format. 

•  Version 2 – This configures the SNMP trap message to use the SNMP V2 format.  

The individual IP addresses of the receiving stations are specified here. Multiple addresses can be 
configured to ensure that the trap message has a better probability of being received. 

This is the community string for the SNMP Manager. See page 29. 
 

 

The access point will automatically generate a trap to signal the cold start condition. This will occur 
if the access point is powered off or a restart is instigated. This trap message is generated about 3 
seconds after the cold start has commenced. This allows the associated IP packet interface to 
power-up and start normal operation. 
 

The access point MIB can be interrogated using a standard RFC1213 MIB Browser. This will allow 
the MIB to be browsed and “walked”. A private MIB is not supported.