Enterasys Networks 2000 Manuale Utente
Hardware Overview
14
Enterasys X-Pedition 2000 Getting Started Guide
LEDs
The 100BASE-FX expansion module uses the following LEDs.
1000BASE-SX Expansion Module
The 1000BASE-SX expansion module contains two independent Gigabit (1000-Mbps) Ethernet
ports. The ports connect to multimode-mode fiber (MMF) cables.
ports. The ports connect to multimode-mode fiber (MMF) cables.
shows the front panel of
the 1000BASE-SX expansion module.
Figure 4. Front panel of 1000BASE-SX expansion module
Table 8. 100BASE-FX expansion module LEDs
LED
Description
Lnk
Each port has two LEDs located to the left of the connector. The
green Lnk LED indicates the link status. When this LED is lit, the
port hardware is detecting that a cable is plugged into the port and the
port has established communication with the device at the other end.
green Lnk LED indicates the link status. When this LED is lit, the
port hardware is detecting that a cable is plugged into the port and the
port has established communication with the device at the other end.
Act
The amber Act LED flashes each time the port’s transceiver sends or
receives packets.
receives packets.
2
1
Rx
Tx
Link
AN
Rx
Tx
Link
AN
1000BASE-SX
G2M-GSXA1-02
Gigabit port
Gigabit port