Enterasys Networks 2000 Manuale Utente
Enterasys Xpedition 2000 Getting Started Guide
33
Installing the Hardware
2.
Plug one end of the console cable into the XP-2000’s DCE DB-9 port.
3.
Plug the other end of the console cable into the management console’s DTE port.
4.
, to power on the switch and boot the software. You will perform initial
setup by entering CLI commands on the management console.
Connecting to the 10/100Base-TX Port
Use the RJ-45 10/100Base-TX DTE port for Telnet connection from a host on the network. The
port is configured for Media Data Interface (MDI).
port is configured for Media Data Interface (MDI).
shows where to plug in to the XP-
2000’s 10/100Base-TX port. The procedure following the figure describes how to set up and insert
the cable.
the cable.
Figure 17. Plugging into the XP-2000’s 10/100Base-TX port
To attach a cable to the 10/100Base-TX port:
CTS (clear to send)
7
CTS (clear to send)
RTS (request to send)
8
RTS (request to send)
Unused
9
Unused
a.
The left hand column pin assignments are for the male DB-9 connector on the XP-2000. Thus, pin 2 (TXD or
“transmit data”) must emerge on the management console’s end of the connection as RXD (“receive data”) and
so on.
“transmit data”) must emerge on the management console’s end of the connection as RXD (“receive data”) and
so on.
Table 16. DB-9 connector pin assignments
Signal (XP-2000 port)
Pin
Signal (management console port)
2
1
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
1000BASE-SX
8
7
6
5
4
3
2
1
10/100BASE-TX
1
3
2
4
CONSOLE
10/100 MGMT
OK
ERR
DIAG
HBT
RST
G2M-HTXA2-08
G2M-GSXA1-02
10/100BASE-TX
10/100BASE-TX
Tx
Rx
Link
AN
Tx
Rx
Link
AN
SYS
Enterasys Networks