TallyGenicom 2365 Guida Utente

1 Check if a proper interface cable is used: Cat.5e, 100 MHz

2 Check if the connected switch or hub is set like the printers in-

terface e.g.

100 MHz, Full duplex

100/Full

or

Autosense

Autosensing

3 Refer to the printers menu. In the printout of the menu settings 

the actual connection link status is reported.

4 The LED next to the RJ45 connector are indicating the link sta-

tus of the ETH-INT.
green off: no link
green flash: link
orange off: half duplex
orange on: full duplex