Hitachi VM-H835LA Manuale Utente
Playback
36
than when recording indoors.
Note: Even if you record outdoors, the LCD monitor backlight may not brighten, if you are
aiming at a dark subject.
Note: Even if you record outdoors, the LCD monitor backlight may not brighten, if you are
aiming at a dark subject.
Playback
You can view recorded pictures on the 3-inch LCD monitor immediately after recording.
1. Open the LCD monitor, and then adjust the angle of the monitor ("Opening the LCD
Monitor", P19).
1. Open the LCD monitor, and then adjust the angle of the monitor ("Opening the LCD
Monitor", P19).
2. Hold down the red button on the CAM/OFF/VIDEO switch while sliding the switch to
VIDEO.
3. Press the REW/REVIEW button to the position where you want to start playback.
4. Press the PLAY button and play back the tape. To adjust the volume, adjust the
Volume control at the bottom of the camcorder.
VIDEO.
3. Press the REW/REVIEW button to the position where you want to start playback.
4. Press the PLAY button and play back the tape. To adjust the volume, adjust the
Volume control at the bottom of the camcorder.
5. Press the STOP button when you have finished.
Note: Decrease the sound volume of the camcorder when you play back a recording by
connecting the camcorder to your TV. If the volume of the camcorder is set to maximum,
the played back picture may be distorted. Make sure that the volume is not set to maximum
during recording as it could distort the played back picture.
Note: When the LCD monitor is turned on and left as it is, the monitor becomes warm, but
this does not indicate fault.
Note: When the CAM/OFF/VIDEO switch is set to CAM or VIDEO, the LCD monitor is
turned on and off automatically when the LCD monitor is opened and closed.
Note: It is recommended that you close the LCD monitor to save the battery power when
playing back a picture on a TV or recording or TV program without viewing it.
Note: Only the playback sound is heard. The sound being recorded is not heard.
connecting the camcorder to your TV. If the volume of the camcorder is set to maximum,
the played back picture may be distorted. Make sure that the volume is not set to maximum
during recording as it could distort the played back picture.
Note: When the LCD monitor is turned on and left as it is, the monitor becomes warm, but
this does not indicate fault.
Note: When the CAM/OFF/VIDEO switch is set to CAM or VIDEO, the LCD monitor is
turned on and off automatically when the LCD monitor is opened and closed.
Note: It is recommended that you close the LCD monitor to save the battery power when
playing back a picture on a TV or recording or TV program without viewing it.
Note: Only the playback sound is heard. The sound being recorded is not heard.
Simple Playback (Using the Electronic Viewfinder or LCD monitor)
1. Insert the cassette ("Inserting and Removing Cassettes," p18).