Meridian Audio 541 Manuale Utente

No lights are displayed when
switching on

❍ Check that your AC power supply is connected correctly.

❍ Check that the ON OFF switch on the rear panel

is in the ON position.

❍ Check that the fuse on the control unit rear panel and the fuse

There is hum on the LP input

The LP input is the most sensitive input on the surround

controller.

❍ Check that the tone arm is connected to the technical ground

of the surround controller.

❍ Check that the tone arm is connected to the power ground in

the turntable.

❍ If you are using a magnetic pickup, check that there is not

another piece of equipment too near to the turntable or the

left-hand side of the control unit. If so, re-position the

equipment to cure the problem.

There is hum on other inputs

❍ Check your other equipment.

❍ Consult your dealer.

There is interference on the radio and/
or television when the surround
controller is switched on

Before following the steps below, ensure all units are switched

off.

If this equipment does cause or suffer from interference to/from

radio or television reception then the following measures should

be tried:

❍ Reorient the receiving aerial (or antenna) or route the antenna

cable of the receiver as far as possible from the surround

controller and its cabling.

❍ Ensure that the receiver uses well-screened antenna cable.

❍ Relocate the receiver with respect to the control unit.

❍ Connect the receiver and this product to different AC outlets.

Troubleshooting