e-pil medtime Manuale Utente

 

Also included with your e-pill system (see below):  

Doserin
g

Styrk

Medicin

Läkare

Namn:

Nat

Midd

Morg

Kväll

Prescription Card

 

Dosage Templates (2)

 

Extra Med-Tray with 
dust cover

 

(4) AA Batteries  

 

Keys (2)

 

Instructions 

2 

 

1. Lid with instructions

2. Display

3. Lock

4. Med-Tray 
(two trays 
supplied 
with one 
dust cover)

Programming Buttons 1, 2 and 3

 

If any fault or malfunction should occur with your Med-Time, 
an ”Err 2” message should appear on the display. If you 
receive this message, remove the batteries, re-program the 
device as necessarry and run the self-test as described below. 
If the fault cannot be corrected, contact your distributor. 
 

Med-Time has a built-in self test function.  
Start Test  
Make sure that the Medication Tray is in the device. Press 
button 1 for at least 10 seconds. The CH message should 
appear on the display. To exit the test mode, press button 3. 
When the display shows CH, Med-Time is ready to be tested. 
To perform a system function test,  press button 2.  
The unit will proceed through the following system test 
modes: 
”CH 1” Display Test: The display shows CH 1. All segments 
on the display shall light up. 
”CH 2” Rotation Test: The display shows CH 2. The motor 
shall rotate the tray one compartment. 
”CH 3” Alarm Signal Test: The display shows CH 3. The 
alarm should sound. Turn the Med-Time over to test reset 
function (as to dispense medicine). The signal should stop. The 
CH 4 message will appear on the display if Med-Time is not 
turned over within 30 seconds. 
 
If the dispenser does not rotate properly the motor will stop 
after a few seconds and display the error message ”CH 6”. 
 
After a few seconds, Med-Time will return to CH Stand by 
mode. Exit the test mode by pressing button 3. 
 
Contact e-pill or AMAC if you encounter any problems with 
your Med-Time unit.