GE ZTD910 Manuale Utente
6
Design Information
Warming Drawer
Installation
Below
Wall Ovens
Below
Wall Ovens
When installed under a wall oven:
Warming drawers are approved for installation
below only certain specified wall oven models.
See the label attached to the top of the
warming drawer for approved models.
• When installed, the front face of the drawer
Warming drawers are approved for installation
below only certain specified wall oven models.
See the label attached to the top of the
warming drawer for approved models.
• When installed, the front face of the drawer
will be nearly flush with adjacent cabinetry
doors.
doors.
• Drawer overlaps will conceal cut edges on all
sides of the opening.
INSTALLATION
BELOW A
SINGLE OVEN
Note:
Additional clearance between
cutouts may be required. Check to be
sure that oven supports above the
Warming Drawer location does not
obstruct the required interior 23-1/2”
depth and 9-1/4” height.
Note:
Additional clearance between
cutouts may be required. Check to be
sure that oven supports above the
Warming Drawer location does not
obstruct the required interior 23-1/2”
depth and 9-1/4” height.
Dim. A
Dim. B
ZKD30
28-1/2”
30”
ZKD27
25-1/2”
26-3/4”
The rough opening for the drawer must be:
– Depth – 23-1/2” min. from inside back to
front of cabinet frame.
– Width – 25-1/2” for 27” wide models,
28-1/2” for 30” wide models.
– Height - 9-1/4”.
– Allow 2” min. between oven and drawer
– Allow 2” min. between oven and drawer
cutouts for clearance of overlaps.
Note: If you are installing in frameless cabinets, it may
be necessary to install 1/2” wide cleats to accept
drawer mounting screws. See drawer for mounting
screw locations.
be necessary to install 1/2” wide cleats to accept
drawer mounting screws. See drawer for mounting
screw locations.
INSTALLATION
BELOW A
DOUBLE OVEN
1" Min. Above Toekick or Adjust
to Oven Installation Height
to Oven Installation Height
A
2" Min.
Allow 5/8"
Overlap on
All Sides
Overlap on
All Sides
B
10-1/2"
23-1/4"
23-1/2" Min.
Inside
Oven
Cutout
9-1/4"
2x2 or 2x4
Anti-Tip Block
Against Rear
Wall, 9" From
Floor to
Bottom of
Block
Anti-Tip Block
Against Rear
Wall, 9" From
Floor to
Bottom of
Block
9"
A
2" Min.
Allow 5/8"
Overlap on
All Sides
Overlap on
All Sides
B
10-1/2"
23-1/4"
23-1/2" Min.
Inside
1" Min. Above Toekick
Oven
Cutout
2x2 or 2x4
Anti-Tip Block
Against Rear
Wall, 9" From
Floor to
Bottom of
Block
Anti-Tip Block
Against Rear
Wall, 9" From
Floor to
Bottom of
Block
9"
9-1/4"