Fortin Auto Radio Inc. ANT900 Manuale Utente

METHOD 2 This method must be programmed by the installer during installation. 
THIS METHOD WILL ACTIVATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE 
VEHICLE.
AUTOMATIC ACTIVATION:

The vehicle must be running.

Make sure the transmission is in the NEUTRAL position.

Engage the parking brake.

Release the brake pedal.

Remove the key from the ignition barrel. The engine will shut 
down and the vehicle will be ready to start at any time.

Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are 
closed.

The vehicle is ready to start. Open any door to cancel Ready Mode and start over the sequence from 
step 1

.

TO DEACTIVATE READY MODE:

 

• Open any door(s)            •     Open the hood          •     Disengage of the parking brake

 

 Note : If the parking lights fl ash 3 times when Remote-Starting, Ready Mode is not enabled.

When the vehicle is running with the Remote-Starter, enter the vehicle and proceed with the following 
steps:

In

sert the key and turn it to the ignition (ON/Run) position.

 WARNING: Do not turn the key to the START position when the engine is 

running. This may damage the ignition system on some vehicles.

Step on the brake pedal to disable the Remote-Starter, and put the 

vehicle in gear.

 

 See USING THE REMOTE CONTROL, page 4

Page 7 / 15