Avaya Media Gateway G700 Manuale Utente

Ignore this message. You must wait until the restart/reset completes before entering 
additional commands.

The media server displays a message that the software update (patch) was applied.

9. Type update_show again and press Enter to list Communication Manager files to verify 

the new software update file was activated.

You must disable RAM disk prior to upgrading the software on the primary controller. To disable 
RAM disk, perform the following steps:

1. Access the server’s command line interface using an SSH client, like PuTTY, and an IP 

address of 192.11.13.6.

2. At the command line, type sudo ramdisk -v -f disabled, and press Enter.

To reboot the media server, perform the following steps:

1. On the Maintenance Web Interface, under Server select Shutdown Server.

2. Select the Delayed Shutdown option. Also, be sure the Restart server after shutdown 

checkbox is selected.

3. Click the Shutdown button. 

Click OK to confirm.

In this section you will restore the system data that you backed up. Do only one of the following 
two procedures, depending on how you backed up the data:

●

●

Note:

The backup and restore processes use the ping service to check connectivity to 
the backup server. If a backup or restore operation fails, ensure that the ping 
service is enabled: 

a. On the Maintenance Web Interface, under Security, select Firewall. 
b. In the Service column, find ping. 
c. The checkboxes for both Input to Server and Output from Server should be 
checked.