High End Systems High End LCD Controller for Studio Color Manuale Utente
Studio Color LCD Controller
Connecting Fixtures
2-17
2
•
A serial data distributor must be used if either of the
following is true:
following is true:
•
You wish to connect more than 32 fixtures to a
controller or more than 32 master/slave controllers
together.
controller or more than 32 master/slave controllers
together.
•
The end-to-end cable span (the total length of all
cables) on any link exceeds 500 ft. (153 m).
cables) on any link exceeds 500 ft. (153 m).
The serial data distributor regenerates and retimes the signal;
failure to use it can result in data errors.
failure to use it can result in data errors.
Examples
Example #1: One controller is connected to 8 fixtures, each
of which will respond independently to control commands.
of which will respond independently to control commands.
Figure 2-12. Each of the eight fixtures connected to
this controller responds independently to control
commands.
this controller responds independently to control
commands.
The example above shows one Studio Color LCD controller
connected to 8 Studio Color fixtures. Each fixture is
numbered 1 through 8 using the fixture’s menus (see
“Configuring the Fixtures” on page 2-9). A terminator must
be attached to the Data Out connector of the last Studio Color
fixture in the link (see “Terminators” on page 2-16).
connected to 8 Studio Color fixtures. Each fixture is
numbered 1 through 8 using the fixture’s menus (see
“Configuring the Fixtures” on page 2-9). A terminator must
be attached to the Data Out connector of the last Studio Color
fixture in the link (see “Terminators” on page 2-16).
XLR data cabling
8 independently-functioning fixtures,
8 unique addresses
8 unique addresses
Fixture #1
Fixture #2
Fixture #3
Fixture #4
Fixture #5
Fixture #6
Fixture #7
Fixture #8
Terminator
Stu
dio
Co
lor
Stu
dio
Co
lor
Stu
dio
Co
lor
Stu
dio
Co
lor
Stu
dio
Co
lor
Stu
dio
Co
lor
Stu
dio
Co
lor
Stu
dio
Co
lor