Verona VECTGMS304SS Istruzione Sull'Installazione

17

 

After injectors replacement adjust the burner flame 

(see Low Flame Adjustment paragraph). 

Check the appearance of each burner’s flame at HI- 

LO settings, if the flame appear too large or too small 

make sure that all steps were completed correctly. 

If this appliance should be converted for use with gas 

NG (natural gas), each of the following modifications 

must be performed. 

1.  Replace all injectors following the step described 

on page 18, observe the number stamped on the 

side, this number codes the orifice diameter and 

its correct burner location (following the illustration 

of injectors position). 

2.  Convert the pressure regulator on LP position (fol-

lowing the illustration of pressure regulator con-

version). 

3.  Adjust the burner flame (see Low Flame Adjust-

ment paragraph). 

Check the appearance of each burner’s flame at HI- 

LO settings, if the flame appears too large or too small 

make sure that all steps were completed correctly. 

The appliances is designed for use with NG gas or LP 

gas. The gas pressure regulator is supplied. It must 

be installed in the gas way ahead of manifold en-

trance. It is pre-set for use with the gas supplied with 

the appliances. For use with different gas must be 

converted. 
For the pressure regulator conversion following 



Disconnect all electrical power, at the main circuit 

breaker or fuse box. 



Shut off the gas supply to the cooktop by closing 

the manual shut-off valve. 



Adjust the pressure regulator, by following the in-

struction (see figure) 

1.  Unscrew the regulator cap 

2.  Unscrew the plastic conversion plug from the cap 

turn over and screw back (wide section away from 

cap for LP and against cap for NG) see figures 

below. 

3.  Replace the cap regulator.