Agilent Technologies E1441A Manuale Utente

Pagina di 206
28
Agilent E1441A Application Information  
Chapter 2
previously specified as a storage location. For example, an error is generated 
if you attempt to recall from memory location “2” but have never stored to 
that location.
+810, “State has not been stored” error is generated if nothing is stored 
in the specified memory location.
Any arbitrary waveforms downloaded to “
VOLATILE
” memory are not 
remembered. However, if an arbitrary waveform is being output from 
non-volatile memory when the state is stored, the waveform data is stored. 
The stored waveform is output when the instrument state is recalled.
If you delete an arbitrary waveform after storing the state, the waveform data 
is lost and the function generator will output the “
SINC
” waveform in place 
of the deleted waveform when the state is recalled.
Use the following commands to save and recall states:
*SAV 0|1|2|3
*RCL 0|1|2|3
You can delete individual stored states and clear the memory location. If 
nothing is stored in the specified memory location, a +810, “State has not 
been stored” 
error is generated. Do not delete state 0 or an error +772 will 
be generated. See “772” on page 148.
MEMory:STATe:DELete 0|1|2|3
Amplitude
Modulation (AM)
A modulated waveform consists of a carrier waveform and a modulating 
waveform
. In 
AM
, the amplitude of the carrier is varied by the amplitude of 
the modulating waveform. The function generator will accept an internal 
modulating signal, an external modulating signal, or both.  Topics covered 
on amplitude modulation are:
AM Carrier Waveform Shape
AM Carrier Frequency
Amplitude Modulating Waveform Shape
Amplitude Modulating Waveform Frequency
Amplitude Modulation Depth
Amplitude Modulating Source
Only one modulation mode can be enabled at a time. When you enable 
AM
the previous modulation mode is turned off. 
Use the following command to select AM modulation:
To ensure proper 
operation, you should enable 
AM
 after you have set up the other modulation 
parameters.
AM:STATe OFF|ON
AM Carrier Waveform
Shape
AM carrier shape:
Sine
, Square, Triangle, Ramp, or Arbitrary waveform. 
The default is Sine.