Falcon F3400 Manuale Utente

Pagina di 94
www.rletech.com
65
970.484.6510
5
  EIA-232 Interface
5.3. Main 
Menu
All system functions begin in the Main Menu. Two letter commands display information, 
execute commands and display submenus for additional inquiry and system configuration 
functions.
The Bootloader section is designed for experienced technicians or users 
responsible for maintaining the system. Exit immediately if you have not been 
trained in the use of the Bootloader commands. Contact RLE for more 
information regarding the commands in this section.
Table 5.1 Main Menu Commands
Command Description
Function
CA
Current Alarms
CA displays all active alarms on the master unit. If alarms 
are present, the System Status LED is red.
KA
Kill Alarms
KA acknowledges all alarms and terminates all dial-out 
communications and network Traps.
TI
Display Date/
Time
TI displays the F3400/F1000's current time and date.
AD
ADC Input 
Values 
AD allows the user to examine the readings of the 4-20mA 
inputs. These readings can be referenced during start-up to 
verify gain and offset calculations. Data displayed depends 
on the expansion card(s) installed.
MS
Modem 
Statistics
MS provides a summary of all modem information.
NS
Network 
Statistics
NS displays network and EIA485 statistics including: 
network packets received, packets transmitted, and errors.
SC
Main 
Configuration
SC displays a submenu that lists all items for system setup 
and configuration.
DU
Dump Network 
Packets
DU dumps the headers of all network packets received and 
sent. Only active until the next command is entered. This 
item is for network debugging only and is not normally 
enabled.
NT
Network Trace
NT displays troubleshooting messages during the 
processing of network packets. Only active until the next 
command is entered. Network Trace is for network 
troubleshooting only and is not normally enabled.
PING
PING
Allows user to PING another device on the network.
EX
Exit to 
Bootloader
EX is used to enter the Bootloader command section. The 
unit will stop monitoring the inputs and allow firmware 
updates to be loaded. To restore normal operation after 
updating firmware, type run and press Enter on the 
keyboard, or power the unit off and back on again.
W
ARNING