Fujitsu M3099EX/EH ユーザーズマニュアル

M3099EX/EH OEM Manual

A-2

ENDORSER

VALUE

* ON

0 0 0 0 5

ENDORSER

VALUE

* ON

0 0 0 0 1

A2. Panel

operation

By the operator panel you can set following conditions. Other conditions
such as print offset, print characters can be set by the host machine.

A2.1 How to set the endorser ON (or OFF)

When you use the endorser, you must set the endorser ON as follows.

1 While pressing the [Mode 1], turn on the

power of the scanner. Then the LCD displays
the SETUP MODE initial screen. (Screen 1)

2 Press [Mode 1] eight times to go to the

ENDORSER INITIAL screen. (Screen 2)
Then press [Mode 2]. If “ON” is displayed,
the endorser is already on. (Screen 3)

3 If “OFF” is displayed, press [Mode 1], until

“OFF” blinks. Then press [Mode 2] to turn
the endorser ON. (Screen 3)

If you want to set the status in EEPROM, go to
5 . Then if you want to close the job, go to 6
and 7 .

NOTICE: Set the endorser ON only when you use endorser, or the

characters may be printed on every scanned document.

A2.2 How to set the initial number

Initial number is the number which the scanner starts printing or returns
after the reset of print number.

4 At Screen 3, press the [Mode 1] until the

digit you want to changes blinks. Then press
[Mode 2] until the digit changes as you want.
(Screen 4: In this case the initial number is
five.)

5 To set the status in EEPROM, press [Mode

1] until * blinks. Then press [Mode 2] to
change the LCD display into Screen 5. If you
want to set, press [Mode 2]. And the LCD
displays Screen 6 about three seconds.

<< SETUP MODE >>

ENDORSER INITIAL

Screen 2

Screen 3

EEPROM WRITE?

(Mode 2 Write)

Screen 5

Screen 4

Screen 1