Fujitsu M3099EX/EH ユーザーズマニュアル
M3099EX/EH OEM Manual
A-4
A2.5 How to reset the print head life counter
You must reset the print head life counter, when you replace the print head.
13 At Screen 1 press [Mode 1] eleven times to
go to INK RESET screen. (Screen 12)
14 Press [Mode 2] to see Screen 13.
If you want to reset the counter, press [Mode
2]. And you can see Screen 14 for 3 sec.
If you don’t want it, press [Mode 1] to go to
Screen 12.
2]. And you can see Screen 14 for 3 sec.
If you don’t want it, press [Mode 1] to go to
Screen 12.
If you want to close the job, go to 7 .
A2.6 How to test the printing by the operator panel operation
You can check the print result by the following procedures.
15 Set the endorser ON by the procedure of the
section A2.1.
16 While pressing the [Mode 2], turn the power
of the scanner on. Then the LCD displays the
MAINTENANCE MODE initial screen.
(Screen 15)
MAINTENANCE MODE initial screen.
(Screen 15)
17 Press [Mode 2] once and press [Mode 1]
once. Place the document on the stacker.
Then press [START].
Then press [START].
NOTICE: The scanner prints the five digit numbers from the initial
number by the increment of one.
NOTICE: Before pressing [START], you can set document size,
resolution and so on. (See OPERATOR’S GUIDE)
<< SETUP MODE >>
INK RESET
Screen 12
INK RESET
No-Mode 1
Yes-Mode 2
Screen 13
RESET Finish !!
Screen 14
<< CE MODE >>
TEST
××
: START
Screen 15