Honeywell K14114 3/06 Rev.B ユーザーズマニュアル
LYNXR-I Installation and Setup Guide
- 8 -
Connecting/Configuring Communication Modules
General
This LYNXR-I supports central station reporting via long range radio and internet. It also supports
upload/download programming capability via the Internet or a Private local area network (Intranet). This
allows site maintenance independent of central station monitoring, and modification to sites globally via the
Internet or through a private LAN. Refer to the instructions provided with the LRR/IP Communications
Device being installed for additional information regarding its installation, programming, and registration.
Zone 103 is the supervisory zone for the Communications Device.
upload/download programming capability via the Internet or a Private local area network (Intranet). This
allows site maintenance independent of central station monitoring, and modification to sites globally via the
Internet or through a private LAN. Refer to the instructions provided with the LRR/IP Communications
Device being installed for additional information regarding its installation, programming, and registration.
Zone 103 is the supervisory zone for the Communications Device.
LYNXR-I does not support the 7845i-ENT remote access feature.
Connecting Long Range Radio and Internet Communication Devices
Connect and configure the communications device as follows (refer to the Installation Instructions for device
that you are installing for additional information):
that you are installing for additional information):
The wire run between the LYNXR-I and the Communications Device must not exceed ten (10) feet.
U
U
U
ULLLL
The 7845ENT and 7845CV2 have been evaluated by UL for Household Burglary installations. The
communications modules have not been evaluated for Household Fire installations.
AlarmNet 7845i-L* Communications Device
1. Install the module into the LYNXR-I back plate and secure it with the two provided screws. Refer to the diagrams below.
2. Connect the provided ribbon cable between the module and the PC board. This cable provides DC power and ground for
2. Connect the provided ribbon cable between the module and the PC board. This cable provides DC power and ground for
the module and data in/data out connections.
3. Connect the device to the Internet via a cable/DSL modem and router or to an Intranet (LAN) via the appropriate Ethernet
connection.
* When available. The 7845i-L module has not been evaluated by UL.
07000-004-V0
LRR / IP PORT
RJ45 (FOR INTERNET
CONNECTION)
CONNECTION)
COMMUNICATIONS
PORT FOR
INTERNAL 7845i-L
MODULE ONLY
PORT FOR
INTERNAL 7845i-L
MODULE ONLY
7720P PROGRAMMER
CONNECTION
CONNECTION
CABLE
Installing the 7845i-L Communications Module