Honeywell 848 ユーザーズマニュアル

 

The Bypass function excludes a zone of protection from the security system until it 
is unbypassed (either by using the unbypass procedure or when you disarm the 
system).  Bypassing can only be done while the system is disarmed. 

NOTE: 24-hour zones may be bypassed, but can only be unbypassed if the zone is 
not faulted (condition has been cleared). 

Press the BYPASS/

 button.  Then enter your user code and the zone number 

to be bypassed, as follows: 

/ 

followed by your user 
code

†

+ Zone 

†

 If the Quick Bypass feature has been enabled by the installer, do not enter the 

user code when bypassing zones. 

NOTE:  Bypassed zones are NOT protected when the system is armed.  After the 
bypass command has been accepted, the keypad sounds one long beep, and the 
following is displayed: 

 

BYPASSED:    ZN 01 
FRONT DOOR 

 

 

BYPASS/

 

Zone number displayed 

 

Zone LEDs of the zone(s) 
bypassed slowly blink 

To Bypass multiple zones, within 10 seconds of the BYPASS/

 + User Code + 

Zone No. entry, enter: 

/ 

+    Zone No. 

This command can be repeated for each zone to be bypassed. 

Pressing the BYPASS/

 button returns a bypassed zone to normal operation. 

To unbypass a zone, the system must be disarmed.  (Also note that 24-hour zones 
cannot be unbypassed if they are faulted.)  To unbypass a zone(s), repeat the bypass 
function as follows: 

/ 

followed by your user 
code

†

+ Zone 

†

 If the Quick Bypass feature has been enabled by the installer, do not enter the 

user code when unbypassing zones. 

After unbypassing, the zone display will show the state of the zones.