Honeywell 848 ユーザーズマニュアル
- 14 -
Disarming the System
When you disarm the system, you disarm only the burglar portion of your system;
any smoke or heat detectors and panic keys will remain armed. You must enter
through a designated entry door and disarm the system within the time allowed.
You can have different amounts of time for different entry points. See your system
reference sheet (page 7) for the times established for your system.
any smoke or heat detectors and panic keys will remain armed. You must enter
through a designated entry door and disarm the system within the time allowed.
You can have different amounts of time for different entry points. See your system
reference sheet (page 7) for the times established for your system.
To disarm your system:
Enter your user code.
If no alarms have taken place, the ARMED/
light will go off, or the display
shows:
LCD Keypad:
SYSTEM READY
Fixed-Glass Keypad:
READY/
✔
LED lit
LED Keypad:
READY/
✔
LED lit
If alarms occurred when the system was armed or if a trouble condition exists, the
display shows:
display shows:
LCD Keypad:
ALM MEM ZN1
Fixed-Glass Keypad:
ARM LED/
lit
READY/
✔
LED blinks
LED Keypad, zone LEDs:
Fast Blink = alarm or tamper
Slow Blink = bypass
Slow Pulse = trouble, problem
with RF receiver, or low battery
Solid On = zone faulted
Slow Pulse = trouble, problem
with RF receiver, or low battery
Solid On = zone faulted
Burglary alarms will sound a steady tone at the keypad(s), and fire alarms will
generate a pulsing sound.
generate a pulsing sound.
IMPORTANT: If an intrusion has taken place while you were away, do not enter
until the location has been checked. Call for help from a neighbor's house and wait
there for the police.
until the location has been checked. Call for help from a neighbor's house and wait
there for the police.
To clear the display of alarm or trouble conditions and silence the audible alert:
Enter your user code again.