Lucent Technologies Release 7 ユーザーズマニュアル
DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
Maintenance for R7r
555-230-126
Issue 4
June 1999
Maintenance Object Repair Procedures
9-1313
POWER
9
lower left corner of the cabinet. Should anything go wrong with the battery or
charger, they must be replaced using the procedure described in the ‘‘Replacing
the Battery and Battery Charger’’ section below. The system will detect one of the
following three problems with the batteries or charger:
charger, they must be replaced using the procedure described in the ‘‘Replacing
the Battery and Battery Charger’’ section below. The system will detect one of the
following three problems with the batteries or charger:
■
Reserve Fault: the charger has detected a problem within itself or the
batteries and has notified the system.
batteries and has notified the system.
■
High Charge Rate: the batteries have been charging at a high charge rate
for an excessively long period of time. This indicates that there is a short in
the batteries or the charger.
for an excessively long period of time. This indicates that there is a short in
the batteries or the charger.
■
Prepare to Disconnect (Low Battery): the batteries are in danger of being
drained to a point where the batteries would be damaged. This warning
often occurs after multiple power failures.
drained to a point where the batteries would be damaged. This warning
often occurs after multiple power failures.
The batteries take 30 hours to fully charge after being drained. A fully
charged battery pack should bridge two power failures without causing a
low battery warning to occur.
charged battery pack should bridge two power failures without causing a
low battery warning to occur.
Replacing the Battery and Battery Charger
(J58890CE)
(J58890CE)
1. Move the power switch on the battery charger to OFF.
!
WARNING:
Always turn off the battery charger before replacing the batteries.
Failure to do so will result in damage to the 397C battery charger.
Failure to do so will result in damage to the 397C battery charger.
2. Disconnect the cord from the outlet on the front of the battery charger.
3. Remove the screw at the top left of the cover and open the cover to
access the charger.
4. Check the battery voltages at the test points. Check all 3 batteries wired in
series (the voltage should be 144 volts, 3 X 48 volts = 144 volts) .
NOTE:
An ordinary voltmeter can be used to check battery voltages at the
test points, but it may not produce valid results. If the battery voltage
readings are below 48 volts (the voltages at test points should read
144 volts, 3 x 48 volts = 144 volts), the battery is probably defective.
However, a normal voltage reading does not necessarily mean the
battery is good; under load, a defective battery with a normal
reading on the voltmeter may discharge rapidly.
test points, but it may not produce valid results. If the battery voltage
readings are below 48 volts (the voltages at test points should read
144 volts, 3 x 48 volts = 144 volts), the battery is probably defective.
However, a normal voltage reading does not necessarily mean the
battery is good; under load, a defective battery with a normal
reading on the voltmeter may discharge rapidly.
5. Check the battery dates and the preventive maintenance log. Replace the
batteries if they are more than 2.5 years-old.