Enterasys Networks 2G4082-25 ユーザーズマニュアル
Completing the Installation of a New System
Pin Out Descriptions
3-16 Installation
Figure 3-11 Matrix DFE Startup Screen Example (N7 Chassis)
Logging in with an Administratively-Configured User Account
If the device’s default user account settings have been changed, proceed as follows:
1.
At the login prompt, enter your administratively‐assigned user name and press Enter.
2.
At the Password prompt, enter your password and press Enter.
The DFE‐Platinum module is now ready to be configured. For information about setting the IP
address and configuring Telnet settings for remote access to DFE management, refer to the
Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide. The CLI commands enable you
to initially set up and perform more involved management configurations.
address and configuring Telnet settings for remote access to DFE management, refer to the
Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide. The CLI commands enable you
to initially set up and perform more involved management configurations.
The Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide is available online at:
If you require assistance, contact Enterasys Networks using one of the methods described in
“
“
login: admin
Password:
M A T R I X N7
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2003
Chassis Serial Number: xxxxxxxxxxxx
Chassis Firmware Revision: xx.xx.xx
Password:
M A T R I X N7
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2003
Chassis Serial Number: xxxxxxxxxxxx
Chassis Firmware Revision: xx.xx.xx
Matrix N7(su)->
Note: Users with Read-Write (rw) and Read-Only (ro) access can use the set password command
to change their own passwords. Administrators with Super User (su) access can use the set
system login command to create and change user accounts, and the set password command to
change any local account password. For information on the set password and set system login
commands, refer to the Enterasys Matrix DFE-Diamond/Platinum Series Configuration Guide
to change their own passwords. Administrators with Super User (su) access can use the set
system login command to create and change user accounts, and the set password command to
change any local account password. For information on the set password and set system login
commands, refer to the Enterasys Matrix DFE-Diamond/Platinum Series Configuration Guide
.