Lexmark 248X ユーザーズマニュアル
59
Section 3: IBM Emulation Mode Printer Commands
Set Top of Form and Page Length
Set Top of Form
This command sets the first line of printing on each page to the current paper
position.
position.
Set Page Length in Inches
This command sets the page length to a specified number of inches.
Usage Notes
• The
value
of
n
is the number of inches you want to set as the page length
and must be between 1 and 255.
•
When the command is sent, the current vertical position becomes the new
top of form.
top of form.
•
If the printer command Set Skip Perforation (ESC N) is active, or if "skip
over perforation" is On in the printer setup, this printer command deacti-
vates it.
over perforation" is On in the printer setup, this printer command deacti-
vates it.
Set Page Length in Lines
This command sets the page length to a specified number of lines.
Usage Notes
•
The value of n is the number of lines you want to set as the page length and
works in conjunction with the current line spacing (ESC A).
works in conjunction with the current line spacing (ESC A).
Format
ESC 4
Decimal
27
52
Hex
1B
34
Format
ESC C
0
inches
Decimal
27
67
0
n
Hex
1B
43
00
n
Format
ESC C
lines
Decimal
27
67
n
Hex
1B
43
n