MGE UPS Systems EX30 ユーザーズマニュアル

Pulsar EX: 51032306XT/BB

29

MGE UPS SYSTEMS

AC outlet

XB2

XB1

(continued)

(option)

The "automatic bypass" module plugs into
the back of Pulsar EX:

c 

unscrew the cover protecting the

connector  15  for the "automatic bypass"
module;

c 

remove the wire linking two of the

terminals of the connector (grounding the
neutral when the automatic bypass module
is not connected);

c 

plug the module  21  into the connector

 15  (see figure 3);

c 

tighten the module using the 2 screws in

the connector  15 .

c 

ensure that the "automatic bypass"

module  21  is properly installed;

c 

take the "manual bypass" module  25 ;

c 

plug the rear connectors into connectors

  4  and  6  of Pulsar EX (see figure 4);

c 

tighten the module using the 2 screws

  24 ;

c 

plug the connecting cable  26  into the

connector  12   of Pulsar EX;

c 

connect the loads having to be supplied

by Pulsar EX:

v 

either directly in the sockets  23  of the

module,

v 

or, in the case of cable connection, open

the cover protecting the terminal blocks,
pass the cable in the left cable-clamp and
connect the 3 wires (phase, neutral and
ground) in the output terminal block  29
(XB2) and put back the protective cover.

c 

connect Pulsar EX to the AC outlet by the

power cable   5   connected to the input
socket   27  of the module, having first
removed the protective cover.
If you cannot use the power cable   5
included with the module, you can made this
cable by yourself, by taking the female plug
of cable   5   included and connecting on it
the 3 wires (phase, neutral and ground) of
your cable as indicated in figure opposite.

c 

do not connect the power cable   5   to the

AC outlet if the battery extension module
option has to be installed, else directly
consult the "operation" section.