MGE UPS Systems EX30 用户手册
Pulsar EX: 51032306XT/BB
29
MGE UPS SYSTEMS
21
15
31
24
26
23
30
29
6
12
AC outlet
7
5
XB2
XB1
1
2
3
27
getting started
(continued)
installing the "automatic
bypass" module
bypass" module
(option)
The "automatic bypass" module plugs into
the back of Pulsar EX:
the back of Pulsar EX:
c
unscrew the cover protecting the
connector 15 for the "automatic bypass"
module;
module;
c
remove the wire linking two of the
terminals of the connector (grounding the
neutral when the automatic bypass module
is not connected);
neutral when the automatic bypass module
is not connected);
c
plug the module 21 into the connector
15 (see figure 3);
c
tighten the module using the 2 screws in
the connector 15 .
Pulsar EX with the "manual
bypass" module ("Hot-
swap" version)
bypass" module ("Hot-
swap" version)
c
ensure that the "automatic bypass"
module 21 is properly installed;
c
take the "manual bypass" module 25 ;
c
plug the rear connectors into connectors
4 and 6 of Pulsar EX (see figure 4);
c
tighten the module using the 2 screws
24 ;
c
plug the connecting cable 26 into the
connector 12 of Pulsar EX;
c
connect the loads having to be supplied
by Pulsar EX:
v
either directly in the sockets 23 of the
module,
v
or, in the case of cable connection, open
the cover protecting the terminal blocks,
pass the cable in the left cable-clamp and
connect the 3 wires (phase, neutral and
ground) in the output terminal block 29
(XB2) and put back the protective cover.
pass the cable in the left cable-clamp and
connect the 3 wires (phase, neutral and
ground) in the output terminal block 29
(XB2) and put back the protective cover.
Figure 3
c
connect Pulsar EX to the AC outlet by the
power cable 5 connected to the input
socket 27 of the module, having first
removed the protective cover.
If you cannot use the power cable 5
included with the module, you can made this
cable by yourself, by taking the female plug
of cable 5 included and connecting on it
the 3 wires (phase, neutral and ground) of
your cable as indicated in figure opposite.
socket 27 of the module, having first
removed the protective cover.
If you cannot use the power cable 5
included with the module, you can made this
cable by yourself, by taking the female plug
of cable 5 included and connecting on it
the 3 wires (phase, neutral and ground) of
your cable as indicated in figure opposite.
G
N
Ph
c
do not connect the power cable 5 to the
AC outlet if the battery extension module
option has to be installed, else directly
consult the "operation" section.
option has to be installed, else directly
consult the "operation" section.
Figure 4