Multi-Tech Systems FF200 ユーザーズマニュアル

Chapter 3:  Server Installation 

Multi-Tech Systems, Inc.           FF200 FaxFinder Fax Server Admin User Guide 

21 

Summary: Place the FaxFinder in a convenient location, and then connect it to your AC power outlet and 

Ethernet. 

Plug the DC power transformer into a power outlet or power strip. Secure the other end to the PWR jack 
on your FaxFinder. The DC power transformer is included with your FaxFinder. 

: Use only the DC power transformer supplied with the FaxFinder. Use of any other 

transformer voids the warranty and can damage the FaxFinder. 

Line 2

Line 1

Ethernet

10/100

POWER

5Vdc

After power is applied, the Power LED comes on immediately but there is a 4-second delay before the 
Status LED comes on.  In normal operation, the Status LED will be flashing. 

When you apply power, the FaxFinder performs a diagnostic self-test. The Status indicator flashes when 
the test is complete and the unit is ready.  If this does not happen, check that the power supply is solidly 
connected and that the AC outlet is live. 

Plug one end of your RJ45 ethernet cable into the FaxFinder’s ethernet jack and the other end into your 
network ethernet hub.  This ethernet cable is not included with your FaxFinder unit.   

L in e  2

Li ne  1

E th er ne t

10/100

PO WER

5V dc

: Before connecting to the Ethernet Network, make sure that the network to which you are 

connecting the FaxFinder is not a 192.168.2.x subnet.  Because the FaxFinder’s factory 
default IP address is 192.168.2.1, connecting it to a network that has a different device at 
that same IP address would cause data interference.