Supermicro 1025W-URB SYS-1025W-URB ユーザーガイド

Chapter 2: Server Installation

2-9

To install the SuperServer 1025W-U/1025W-UR into a Telco type rack, use two 

L-shaped brackets on either side of the chassis (four total). First, determine how 

far follow the server will extend out the front of the rack. Larger chassis should be 

positioned to balance the weight between front and back. If a bezel is included on 

your server, remove it. Then attach the two front brackets to each side of the chas-

sis, then the two rear brackets positioned with just enough space to accommodate 

the width of the telco rack. Finish by sliding the chassis into the rack and tightening 

the brackets to the rack.