Supermicro 1025W-URB SYS-1025W-URB 用户指南
产品代码
SYS-1025W-URB
Chapter 2: Server Installation
2-9
Installing the Server into a Telco Rack
To install the SuperServer 1025W-U/1025W-UR into a Telco type rack, use two
L-shaped brackets on either side of the chassis (four total). First, determine how
far follow the server will extend out the front of the rack. Larger chassis should be
positioned to balance the weight between front and back. If a bezel is included on
your server, remove it. Then attach the two front brackets to each side of the chas-
sis, then the two rear brackets positioned with just enough space to accommodate
the width of the telco rack. Finish by sliding the chassis into the rack and tightening
the brackets to the rack.
Figure 2-6. Installing the Server into a Telco Rack