Smeg CS15-5 ユーザーズマニュアル
Installer Instructions
6
2 INSTALLING THE APPLIANCE
The appliance must be installed by a qualified technician and in accordance with the regulation s in
force.
It can be installed against walls where one of them is higher than the hob as illustrated in figures A
It can be installed against walls where one of them is higher than the hob as illustrated in figures A
and B in relation to the installation classes. The hanging furniture and suction hoods located above
the hob must be at least at a distance of 750 mm.
the hob must be at least at a distance of 750 mm.
A
B
2.1 Electrical connection
Make sure that the voltage and size of the supply cable correspond to the characteristics detailed on
the identificationplate inside the storage compartment. Do not remove this plate for any reason.
the identificationplate inside the storage compartment. Do not remove this plate for any reason.
If the appliance is connected to the power grid by means of a fixed connection, an all-pole switch
must be installed on the supply cable with a contact opening distance of at least 3 mm, and it must
be located close to the appliance in a readily accessible place.
must be installed on the supply cable with a contact opening distance of at least 3 mm, and it must
be located close to the appliance in a readily accessible place.
The connection to the power grid may be permanent or by means of a plug and socket. In the latter
case, they must be suitable for the cable in use and must meet the regulations in force. The
appliance must be earthed for every type of connection. Before it is connected up, you must ensure
that the supply cable is equipped with a suitable earth electrode. Avoid using adaptors which could
cause overheating.
case, they must be suitable for the cable in use and must meet the regulations in force. The
appliance must be earthed for every type of connection. Before it is connected up, you must ensure
that the supply cable is equipped with a suitable earth electrode. Avoid using adaptors which could
cause overheating.
In case of replacement of the supply cable, the wire section of the
new cable should be no less than 1.5 mm
new cable should be no less than 1.5 mm
2
(3 x 1.5 cable), taking into
account the fact that the termination to be connected to the appliance
must have an earth wire (yellow/green) at least 20 mm longer. Use a
H05V2V2-F cable or equivalent, excluding all other cable types. The
cable must be resistant to a maximum temperature of 90°C. It must
be replaced by a specialised technician who will need to connect it to
the power grid in accordance with the appropriate diagram.
L = brown
N = blue
must have an earth wire (yellow/green) at least 20 mm longer. Use a
H05V2V2-F cable or equivalent, excluding all other cable types. The
cable must be resistant to a maximum temperature of 90°C. It must
be replaced by a specialised technician who will need to connect it to
the power grid in accordance with the appropriate diagram.
L = brown
N = blue
= yellow/green.