Cetacea Sound was-pd2-owl クイック設定ガイド
QUICK START GUIDE
Walk Around Sound Amplifier
With OWL Speakers
Model No. WAS-PD2-OWL
Model No. WAS-PD3-OWL
Model No. WAS-PD3-OWL
1.
There are three (3) source-input plugs on the Walk Around
Sound (WAS-PD3) and two (2) source input plugs on the (WAS-PD2)
amplifier base that can accept either mono or stereo inputs depending on
your “source”, i.e., computer, VCR, DVD, VCD, etc.
2.
amplifier base that can accept either mono or stereo inputs depending on
your “source”, i.e., computer, VCR, DVD, VCD, etc.
2.
The WAS-PD2 is identified by the 2 inputs and one line output
marked “output”. Be sure not to use the “output” as an input, it has a
special application.
3.
special application.
3.
In order to connect to the amplifier, use a single male-to-male
extension similar to the one supplied with your system accessories. One
end will fit the source “output” and the other will plug directly into one
of the WAS-PD inputs labeled A, B, or C, depending on your model.
Refer to the hook-up drawings on your specification sheet if you have
questions.
4.
end will fit the source “output” and the other will plug directly into one
of the WAS-PD inputs labeled A, B, or C, depending on your model.
Refer to the hook-up drawings on your specification sheet if you have
questions.
4.
Do not adjust the volume on the “sound source” above 75 %,
because computers, VCR’s, and CD players exhibit distortion at high
volume levels.
5.
volume levels.
5.
Turn the volume down as low as it will go (counter-clockwise)
on your WAS-PD amplifier (the large disk on top with the finger
dimple).
6.
dimple).
6.
If your sound source has a “BASS BOOST”, or special effects
like Spatializer, SRS, or controls that say “JAZZ”, “ROCK”, “BLUES”,
etc., turn them off for now! Also turn off all computer DSP’s.
7.
etc., turn them off for now! Also turn off all computer DSP’s.
7.
The WAS-PD amplifier requires power from the “Switchable
Power Supply”. Plug the power supply into a suitable source of power
(100-240v) and the opposite small end into the base of the WAS-PD
amplifier. (It will only fit in one location.)
8.
(100-240v) and the opposite small end into the base of the WAS-PD
amplifier. (It will only fit in one location.)
8.
Plug the speaker cables into the left and right output jacks on the
WAS-PD. Turn on the sound source and slowly turn up the volume on
the WAS-PD. Be sure to use a high quality recording to fully appreciate
the awesome sound of the speakers. See instructions on other side for
mounting OWLs to the wall.
the WAS-PD. Be sure to use a high quality recording to fully appreciate
the awesome sound of the speakers. See instructions on other side for
mounting OWLs to the wall.
(OVER)
5RMF-WASPD(2)(3).doc