Motorola accompli 008 ユーザーガイド
20 Getting Started
Complete Process of Turning On Your Device
If you have pre-set the PIN, phone number lock or the device is preset with manual network
selection (refer to System Setup), you will need a few more steps to turn Phone Mode ON. But it
also enhances the security of your phone and the versatility of its functions.
Open the flip then press the Power button and hold the button until the screen shows the Phone
Mode dialogue box, then release.
If the SIM card is not inserted, locked, not registered or damaged, the screen will show the
following
2 selections:
selection (refer to System Setup), you will need a few more steps to turn Phone Mode ON. But it
also enhances the security of your phone and the versatility of its functions.
Open the flip then press the Power button and hold the button until the screen shows the Phone
Mode dialogue box, then release.
If the SIM card is not inserted, locked, not registered or damaged, the screen will show the
following
2 selections:
b
12:26
No SIM Card!
Continue with:
Antenna Off
Antenna On
Power Off
OK
!
Tap Antenna OFF then press OK, the phone will operate in PDA mode. Calls cannot be made,
short messages cannot be sent, etc.
Tap Antenna On and then OK, the phone can make Emergency Calls (if the SIM is locked or
registered) and use the PDA functions. Refer to the Security Setup under System Setup.
Tap Power Off to turn off the device.
short messages cannot be sent, etc.
Tap Antenna On and then OK, the phone can make Emergency Calls (if the SIM is locked or
registered) and use the PDA functions. Refer to the Security Setup under System Setup.
Tap Power Off to turn off the device.
If the SIM card is working and the PIN is set the following screen will prompt you to key in your PIN
as follows:
as follows:
12:26
Enter SIM Pin
P
D
A
M
o
d
e
E
n
t
e
r
To enter the PDA mode, simply select PDA Mode to turn on the phone. Alternatively, key in your
PIN (for security reasons, the screen will only show # to represent each digit; to correct the last
digit, simply press
PIN (for security reasons, the screen will only show # to represent each digit; to correct the last
digit, simply press
to delete the last digit).