Frigidaire fah086r1t インストール手順

Rear Louvers

60°

7"

60°

Top View

15"Deep

1. Redirect the louvers at the back of the wall sleeve as shown 

    opposite. The use of pliers is recommended.

2. Attach (1) 1 ½” x 3/8” x 25” long seal in the center at the 

    top of the sleeve. Remove the backing paper and press 

    into position.

3. Attach (2) 1 ½” x 3/8” x 14” seals to the left and right sides 

    of the sleeve.

4. Cut the 1 ½” x 3/8” x 25” long seal to 14” long and attach 

    it to the vertical section of the rear grille as shown.

5. Attach (2) 4 ½” x 3 ½” x 1 ½” centering/support blocks 

    one on each side wall. Place in center of side wall with 

    the tapered end facing the opening. 

6. Gently slide unit into sleeve. 

7. Before sliding all-the-way back, remove 2nd screw from 

    front on left side of unit. 

8. Remove the plastic washer from the screw. 

9. Screw and attach the other end of the ground wire to 

    the unit as shown in picture. Make sure that the toothed 

    washer is against the cabinet.

10. Slide the unit completely to the rear to ensure a good 

      seal, making sure the ground wire does not become 

      tangled.

11. Seal & Frame the unit as described on the last page of 

      these instructions.

3

←

←

7"

→

→