Microtek 1000xl ユーザーガイド

12     ScanMaker 1000XL Supplement

To scan 6 x 4.5 cm, 6 x 6 cm, 6 x 7 cm, 6 x 9 cm, and 6 x 17 cm panoramic film, use the
120 Film Template, which can hold up to 4 pieces of 6 x 4.5 cm film, 2 pieces of 6 x 9 cm
film, or a single piece of 6 x 17 cm panoramic film.

1. Place the 120 film to be scanned inside the frame of the 120 Film Template. The

shiny base of the 120 film should be facing down, and the emulsion side of the
film should be facing up.

2. Load the Black Plate into the template frame, with the side of the Black Plate that

reads “This side up” facing up. Slide the Black Plate until its edge is against the
film and completely covers the blank spaces of the template.

Orient template with
"Microtek" logo facing up

3. Place the 120 Film Template containing the loaded film on the scanner glass

surface. Make sure to orient the template with the “Microtek” logo facing up.

Align the edge of the film frame
with the arrow mark of the template

2

1

0

3

4

5

6

6

5

4

3

2

1

The  Grabber is used to remove the
template out of the scanner glass
surface.

Important: Align the template's
front corners firmly against the top
corners (left and right) of the
U-shaped ruler located at the front
of the scanner. During placement of
the template, make sure that the
calibration strip on the scanner
glass surface is kept clear and free
of obstruction at all times.

Calibration strip

Microtek logo

Remove the Black Plate from the 120 Film
Template before loading the 120 film